HYDRAULIC TOOLS

STANLEY Hydraulic Tools

Stanley
Diamond Chain Saw

Stanley DS11

The DS11 Diamond Chain Saw is specifically designed to cut solid concrete underwater. Cuts square corners without over-cut and can plunge cut sea walls up to 18″ thick. Two available bar lengths (15″ and 18″) and two different chains depending on the amount of rebar and hardness of the concrete.

A minimum of 20 PSI water pressure is required at the saw for cooling and lubrication of the bar and chain. Painted hi-visibility yellow.

DOWNLOADS
  • Direct drive motor – no chain coast when trigger is released
  • Integral Stanley Hyrevz gear motor for durability and power
  • Trigger activated water to bar and chain for lubrication
  • Multi position trigger handle and Wall Walker reduces diver fatigue
  • Heavy duty cast aluminum
  • Cut steel reinforced concrete with Pinnacle chain
  • Stainless Steel spool and fasteners
  • Interlocking safety trigger and hand guard
  • Pinnacle Chain: For Steel Reinforced, Heavy Aggregate Concrete
  • Ultra Chain – For Light Wire Mesh, Soft/Green Concrete
  • Order bar and chain separately – See Chart for Selection
TECHNICAL SPECIFICATIONSSTANLEY DS11
Capacity15 or 18" / 38 or 45 cm Bar
Chain TypeDiamond Impregnated Chain Segments
Circuit TypeOpen Center
Flow Range12 gpm / 45 lpm
Working Pressure1000-2000 psi / 70-140 bar
Full Relief Setting2250 psi / 155 bar
Weight (less bar & chain)28 lbs / 12.7 kg
Length (with bar & chain)37 or 40" / 99 or 101.6 cm
Width9" / 23 cm
CouplersYes
Hose WhipsYes (½" NPT Male Thread)
Lubrication/CoolingInternal Water Channels in Bar
DESCRIPTIONPART NUMBERS
DIAMOND CHAIN SAW STANLEY DS11
DIAMOND CHAIN SAW Capacity 45cm 26-34L/min CE Underwater Supplied without bar & chain - Cuts concreteST-DS115000