HYDRAULIC TOOLS
DOA & STANLEY Hydraulic Tools
Stanley Hydraulic Tools
Hydraulic Pumps
Stanley TP08
With over 800 gpm of output flow, this pump is capable of pumping high volumes of water, sand slurries gravel, mud and solids up to 4″ in diameter. The TP08 is used for dewatering, dredging, cleaning and as a effective bilge pump. The gear motor is direct drive to the cast iron impeller with easy access for clean out of the fabricated steel volute. See chart below for gpm discharge at flow.
DOWNLOADS
FEATURES
- Submersible and Self Priming
- Dredges solids up to 3″ in size
- Removes sand, clay and mud from work structures
- 800 gpm (3,028 lpm) discharge
- Easy volute inspection and clean out
- Can run dry without damage
- 4″ discharge
- Steel volute, cast iron impeller & polyethylene wear plates
- CE Certified
SPECIFICATIONS
| TECHNICAL SPECIFICATIONS | STANLEY TP08 | |||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Capacity | 4" NPT with 4" Camlock | |||||||||||||
| Performance | 800 gpm / 3,028 lpm | |||||||||||||
| Flow Range | 7-10 gpm / 26-38 lpm | |||||||||||||
| Working Pressure | 2000 psi / 140 bar | |||||||||||||
| Full Relief Setting | 2250 psi / 155 bar | |||||||||||||
| Weight | 63 lbs / 281/2 kg | |||||||||||||
| Length | 18" / 45.7 cm | |||||||||||||
| Width | 19" / 48.3 cm | |||||||||||||
| Hydraulic Ports | 10 SAE pressure / 12 SAE return | |||||||||||||
| Connection | ½" NPT | |||||||||||||
| Couplers | Yes | |||||||||||||
| Hose Whips | No |
REFERENCES
| DESCRIPTION | PART NUMBERS | |||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
| TRASH PUMPS STANLEY TP08 | ||||||||||||
| Steel impeller Steel body 26-34L/min CE 4" NPTF discharge - equipped 4" Camlock Solid 100mm - Flow up to 3000L/min - Water head 13m | ST-TP08013 |