The Viking VTS is a trilaminate lightweight, but robust suit designed for use by divers where contaminated water is not an issue, but strength and puncture resistance is a must. VTS suits feature stitched external seams, and internal seams sealed utilising our unique “Vulca Seam technology”. The suits are easy to transport due to the low weight, and ease of storage. Viking VTS suits are in use worldwide with not only sports and technical divers, but also special forces, Police dive teams and fire rescue squads.

FABRIC
Two material options are available as follows:

• 450 g/m2 Cordura textured outer / Butyl midply / Polyester inner. Light and strong. Good puncture and abrasion resistance
• 400 g/m2 Polyester outer / Butyl midply / Polyester inner. Softer warmer feel than nylon. Good puncture and abrasion resistance

SEAMS
External seams stitched together. Internal seams are chemically treated and then an uncured rubber tape is applied to the seams using heat and pressure. Finally the suit is placed inside a vulcaniser whereby the rubber tape becomes cured into the material surface. This is known as “Vulca Seam technology”.

REINFORCEMENTS
The Viking VTS materials are inherently abrasion and puncture resistant. Soft, flexible and hard-wearing knee pads are fitted as standard.

VALVES
The standard configuration includes the following valves installed on canvas reinforcement discs:

• Push-protected inflation valve, located in the center of the chest strap.
• Hose: CEJN connector, 80 cm long.
• Low-profile bleed valve located on the left arm.

FOOTWEAR
Factory-fitted 5 mm canvas-lined neoprene boots. Suits can be requested with latex socks if the suit is to be used with overshoes.

STANDARDS
EN 14225-2:2017