HYDRAULIC TOOLS
DOA & STANLEY Hydraulic Tools
Stanley Hydraulic Tools
Chipping Hammers
Stanley CH15
The ergonomic “D” handle and short 17″ over all length, makes it easy to use in confined and hard to access locations. The floating trigger design requires minimal pressure across any part of its surface to engage the tool. The trigger is protected within the handle to prevent accidental operation of the tool. The CH15 has a solid bit retainer and will accept. 580 hex shank, oval collar tool bits. Painted hi-visibility yellow.
DOWNLOADS
FEATURES
- Ergonomic “D” handle with inside trigger
- Stainless Steel spool and fasteners
- Tool body has rubber coating for diver comfort
- Floating trigger design requires minimal pressure
- Uses standard .580 hex shank, oval collar tool bits
- High power to weight ratio
- Operates in any position
- CE Certified
SPECIFICATIONS
| TECHNICAL SPECIFICATIONS | Stanley CH15 | |||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Steel Capacity | .580 Hex Shank, Oval Collar Tool Bits | |||||||||||||
| Handle Type | ”D“ Handle, with Inside Trigger | |||||||||||||
| Circuit Type | Open Center | |||||||||||||
| Flow Range | 7-9 gpm / 26-34 lpm | |||||||||||||
| Optimum Flow | 8 gpm / 30 lpm | |||||||||||||
| Working Pressure | 1000-2000 psi / 70-140 bar | |||||||||||||
| Full Relief Setting | 2250 psi / 155 bar | |||||||||||||
| Weight (less tool bit) | 16 lbs / 7.25 kg | |||||||||||||
| Length | 17” / 43 cm | |||||||||||||
| Hydraulic Ports | -6 SAE O-ring | |||||||||||||
| Couplers | Yes | |||||||||||||
| Hose Whips | Yes (3⁄8" NPT Male thread) |
REFERENCES
| DESCRIPTION | PART NUMBERS | |||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
| CHIPPING HAMMERS STANLEY CH15 | ||||||||||||
| CHIPPING HAMMER 7,2kg - Oval collar 30L/min CE | ST-CH1533101 |