The Surface Display Pro' has been designed to provide a remote method of verifying the corrosion voltage readings of the BathyCorrometer® Pro'.

The Surface Display Pro' (which would typically be on board a ship or on a platform) connects to the BathyCorrometer® (being used underwater by a diver) via a robust, two core water resistant cable of suitable length (supplied separately). Using a 4-20mA signal, the voltage reading on the BathyCorrometer® is mirrored on the Surface Display Pro', allowing for quick and easy verification.

It is recommended that the SDU is purchased with the BathyCorrometer® it is going to be used with, this allows both units to be checked working together.

Note: The Surface Display Unit is not suitable for use with old Roxby BathyCorrometers, those fitted with Buckleys Retro-fit kits or early Buckleys units.

Kit comprises:

• SDU unit
• Mains supply lead
• Calibration leads from BCM to SDU
• Full instruction manual

Also required:

• Two core connection cable (length to customer's requirements)